вот что пишет Новозеландец, говорит тянуть пока вал не начнет крутицо с трудом, дабы получить предзагрузку подшибников, и увеличив это контакт пар .... (но это его imho)
например ступичный на транзите тоже затягивается пока колесо не начинает с трудом крутится и потом отпуск на 90 градусов поворота ключа, может тут подобно поступить ? только отпустить не на 90 а ну скадем на 45
You need to get the gear contact pattern and backlash correct, then you need to get a bit of preload on the bearings. I was told that the standard bearing preload is very soft, and should be increased until the breakaway torque for the input is starting to get difficult by hand.
I haven't been running the transfer case long enough to make any comment on how good this is though, I will of course say something if my bearings blow up.
|